Re: Applicard CP/M partition on CFFA3000?

[EricN <ericn247@gmail.com>]

More details on mounting a CP/M partition. Good suggestions from
everyone, but still no luck so far:

- CFFA is in slot 7 of an enhanced //e with SmartPort assigned
CompactFlash image (set to both drive 1 and drive 2 with same results)
- Started with stock bootable 32MB ProDOS image and attempted to use
ProPart to partition. ProPart hangs towards the end of the partition
process where it's trying to write the data blocks
 - Image was generated by CiderPress and one was also derived from
stock CF image shipped with CFFA card. Same results from both

The emulation idea was a good one, however, I don't know of any
emulator that supports the Applicard.  I tried running Pro/Part in
Virtual ][ with the generic-Z80 card, but Pro/Part won't run in that
environment so I can't make a CP/M partition image to transfer over to
the CFFA.

So no issues booting any kind of ProDos image I can create. I just
can't seem to create a CP/M image from any Pro-DOS image, and I don't
have an exiting CP/M hard disk image to transfer onto the CFFA.

If anyone has an existing CP/M image for Applicard, that would be very
helpful.

Thanks,
Eric