On 11/03/2011 06:51 PM, James Littlejohn wrote:
The DIY package is available, visithttp://www.spvhd.org/- chapter 4. Antoine
I was not aware these were already being sold! I must get one(or three). ;)
Only the bare-board + parts kits are available. Cedric is still working on the enclosure for finished units.
If you can get your hands on DB19 M&F connectors and have a decent bench setup, construction is not too bad. Took me a couple of evenings.
I found a 25pin serial cord in my junk bin with 18-conductors + shield and used the wire for the drive cable. The entire thing fit in a little Velleman project box about 4 x 1-3/4 x 1-3/4".
Steve