Re: I require information IIGS monitor

["Hilary M. Turner" <hilarymichael@ozemail.com.au>]

 I figured as much and took out the 1000 ohm and checked it to start with  it was
OK then have started going in the other direction. It took a blue cap and out
with it but the transformer seems to be good but still looking.

"Michael J. Mahon" wrote:

> Hilary M. Turner wrote:
>
> >Funny you should mention that. I am using 240v and the ceramic you are
> >talking
> >about is a 6.8 ohm on my board as well as most of the other capacitors are
> >more
> >then just double  than what you would find on a 110 system.
> >
> >    I watched as when I switched on and it glowed through the ceramic coating
> >and
> >burned out.
> >
> >    Thanks for the hint.
>
> And you should also know that this "fusible resistor" does not usually
> burn out unless there is an unusual load on the power supply--probably
> caused by a shorted component.  It can be a little tricky to find.
>
> -michael
>
>  Email:  mjmahon@aol.com
>  Home page:  http://members.aol.com/MJMahon/