Re: Memory expansion for II+

[waynes@intergate.ca (Wayne Stewart)]

ikanja@yahoo.it wrote 
> Well, actually for IIeuroplus but I think that is the same.
> I found a card that seems to be a 16K ram expansion. I know that it goes
> in slot 0 but I don't know where the cable starting from the card should
> end. There's no free socket on the board so I guess that I should
> replace one of the chip on the board with the connector at the end of
> the cable. but which is the rigth one?
> 
> Also, how do I activate the new memory? Is there a program to do that or
> software that can take advantage of the expansion automatically
> recognize it?

The cable goes to the memory chip on the rear left. If you check the card 
you'll find 9 memory chips or an empty socket for the one off your board.

Apples DOS Master will automatically load interger basic into it. You also
need it to run any version of ProDOS except I believe the first version. 
There were a lot of program written to use it as a RAM disk. 

	Wayne