Re: PCB drill working

[aiiadict@hotmail.com (Rich J.)]

"Mark Cummings" <NOTfigjams@primus.com.au> wrote in message news:<3b1b8703@news.iprimus.com.au>...
> For that to work you will have to sit the PCB up off the cutting table a bit
> using some kind of spacer, to allow for the tapered end of the drill bit,
> otherwise your holes will not be complete.

Yes, that is a good point.  A spacer the thickness of the distance
from the tip of the bit to where the taper ends.  I may add some sort
of microswitch or encoder to get drill depth feedback from the plotter.

> BTW: your sitename does not seem to work.

http://rich12345.tripod.com

no www!

Rich