Re: ZipGS wont print to HP Deskjet

[ladyphoenixxii@my-deja.com]

In article <1e7m1l8.41znge1o7e1q0N%dempson@actrix.gen.nz>,
dempson@actrix.gen.nz (David Empson) wrote:
> <warnken@mother.com> wrote:
>
> > I transferred my Focus hard drive to the backup system, which is also a
> > ROM3 but with a ZipGS accelerator. The system works great. None of the
> > problems exist that were in the TransWarp. When I try to print from
> > Appleworks GS with Grappler+, Harmony driver I get a message "Select not
> > on" same message with a differnt hard drive. Both hard drives will print
> > on the TWGS and the cpu with out the ZIP printed, so it's a Zip problem.
>
> Assuming this is just a "slot running too fast" problem, you should be
> able to fix it by changing one DIP switch.
>
> Switches 1 to 7 in bank 2 determine whether the ZipGS slows down on eacg
> access to the corresponding slot. If the Grappler is in slot 1, try
> setting switch 1 in bank 2 to the OFF position, which will enable the
> delay. (You should power down the computer first, so that you can be
> certain the ZipGS recognises the switch change.)

Funny thing the control panel shows all the settings switch one backwards. 
The slot one switch when toggles to normal, goes back to fast when I reboot. 
I didn't get the software with the Zip, someone sent it.  Is that a problem?



> There might be a problem if you have a particularly fast ZipGS. The
> compatibility list in the manual probably reflects a 7 MHz or 8 MHz
> ZipGS.
It says 9MHZ

> David Empson
> dempson@actrix.gen.nz
> Snail mail: P O Box 27-103, Wellington, New Zealand


Sent via Deja.com http://www.deja.com/
Before you buy.