Newly back into this hobby after dusting off my old Apple IIe and
starting to get some software transferred over with ADTPro. I only had
a single floppy drive but recently came across a few drives that I
decided to try with my apple. I suspect that each one has a problem
because none of them seem to work as expected (one causes drive 1 to
spin but not boot, one causes drive 1 not to boot at all - immediately
goes to a command prompt, and one seemingly works but crashed ADTPro).
So I just want to confirm that there is no configuration I need to do
when adding a second drive, right? Just plug and boot? I don't see any
jumpers or anything.