Re: Grappler help

[Rubywand <rubywand@swbell.net>]

LFessen106 writes ...
> 
> I have an Apple //e with a Grappler printer interface + cable, however the
> cable looks to have an IEEE-488 end on it.  Is there a printer that uses this
> type of interface?  Can I construct a different cable for this?  I was under
> the assumption that grappler was a paralell interface..
 ....

     That sounds right. We did our own parallel interface and never got around to
trying a Grappler. According to a post by Mitch Spector, a card called the
"Grappler+" uses the usual Centronics parallel cable:

>>

Grappler+ Pin Assignments 
~~~~~~~~~~~~~~~~~~~~~~~~~ 
STB   1 
D0    3 
D1    5 
D2    7 
D3    9 
D4    11 
D5    13 
D6    15 
D7    17 
ACK   19 
BUSY  21 
P.E.  23 
SLCT  25 
N/C   - 
GND   all others 

<<




Rubywand