Re: Boot Order Question

[Wayne Stewart <waynes@intergate.bc.ca>]

Missed the original post but to do this
place the Vulcan controller in a slot (preferably slot 7, alternatively slot
1 or 2). Then go into the control panel and under slots set that slot to
"your card" and then set the startup slot to 5 if you want it to start up
on the 3.5 floppy drive or 6 if you wish to startup on the 5.25 drive.


>
> > I'm trying to reformat and load my iigs with a vulcan card. The
> > problem I run into is when I wipe the boot partition on the vulcan,
> > when my gs boots, it tries to boot from the vulcan, not the floppy.
> > How do you get around this? I tried moving the vulcan to another slot,
> > which gets it booted from the floppy, but then I can't access the
> > Vulcan!!
>
>