Re: Super Serial Card II, Modem/Term Block

[david@uow.edu.au (David Wilson)]

wbdesnoy@acs2.acs.ucalgary.ca (Byron Desnoyers Winmill) writes:
>While playing with my serial card I managed to break pin 9 on the 
>modem/terminal switch block.  Is this pin significant?  If so, how would 
>I wire-up a new connector or bypass this pin?

This is from memory (I can only lay my hands on the 2nd edition of the SSC
manual - the dumbed down one with no circuit diagram) but if you can get
a male DIP header solder the following pins and you will have a replacement
module.

	1-16
	2-15
	3-14
	4-13
	5-11
	6-12
	7-9
	8-10

No idea what signal goes through pin 9 nor which orientation of the above
results in terminal or modem mode.

Does it still work with the broken pin?
--
David Wilson  School of IT & CS, Uni of Wollongong, Australia  david@uow.edu.au