Re: Titan Accelerator //e

[spec@vax2.concordia.ca (Mitchell Spector)]

In article Sean Fahey <sfahey@unicom.net> writes...

>Does anyone have the documentation for the Titan Accelerator //e?  I'd
>like to know the correct settings for the switch blocks.

    According the (photocopied) manual that came with my Titan board,
switches 1, 2, 3 and 8 are reserved for diagnostics and should always 
be set to the 'ON' position. Switches 4 through 7 correspond to slots,
and should be set to 'OFF' _only_ if you have a timing sensitive card
or device installed (e.g. disk controller, video digitizer, etc).

    Older/newer revisions of the card may have had switches 1 to
7 correspond to the internal slots, though I can't test it properly 
since my card seems to be defective (sadly I've had to remove it and 
let it go to waste in a box, like the defective TransWarp GS I own :/).
One of these days I like to repair it, it runs faster than my stock
Apple IIgs and Apple IIc Plus. :-)

Mitchell Spector
spec@vax2.concordia.ca