Re: AWK 3.0 printing problem

[aw133@lafn.org (James Poore)]

In a previous article, raymondp@cris.com () says:

>>>I'm using an FX 80 with a //e
>>>
>>>
>>You have to go into the setup screen for the printer and enter the
>command
>>equilvalent of a CTRL-I"0N". That should take care of your problem.
>
>I tried it on the interface command set up ... I previously had  'CTRL-I
>80N' and it has always worked fine.  '0N'  does not eliminate the
>problem....
>
>Normally when I'd print the % bar shows fine ..... now the get misc
>reverse characters on the top two lines of the screen when it's printing.
>Could it be failed Grappler + card firmware?

It could be but doubtful since you said it works ok with proterm.
Check switch settings on the Grappler + for the right settings for your 
printer and if the switch settings are correct then you might try setting 
sw 1 on the Grappler + to on which will bypass the Grappler's firmware 
and run like a plain vanilla parallel card.

Jim

-- 
James M (Jim) Poore--Apple II's Forever--Especially IIgs's
Los Angeles Free Net---aw133@lafn.org
Here siggy, siggy...Here Boy
Where is that damn SIG?