Re: RAMFactor help, please

[aw955@FreeNet.Carleton.CA (Robert Hoover)]

"Jason Whorton" (chesster@pcl.net) writes:
> Hello.  I recently purchased a used system that had a RAMFactor card in it.
>  I am needing help in figuring out if the card actually works or not.  Do I
> have to have some special AE software to get it to working right?  Most of
> the time when I try to warm boot with the card in, it has some (I think)
> hexidecimal characters across the top of the screen.  Occasionaly, it will
> just have a blob of different colored blocks all over the screen.  If
> anyone can give me any information on how to test this card to see if it
> works, I would appreciate it.  Also, I bought a RAMCharger for it.  Is
> there a possibility that the RAMFactor thinks it is connected to the
> RAMCharger, or it is supposed to be?  If anyone has any information they
> could pass along about it, I would greatly appreciate it.

Well I am using a used RAMfactor in my //e in slot 4.  You can start buy
droping to the "]" prompt in basic and then init #4 and you get the
software ( I think ) I have been muddeling around I and basically use it
as a ram disk for pt3 and extended memory for PT and it works ok as long
as I keep the scroll back below its asigned level. 

BTW - is there a site somewhere where we could FTP the AE software from ?
and can you get replacement batteries for the RamCharger ? Mine is dead.

	-R

--
I want to leave this world that way I can into it,
Screaming, Naked and Covered in Blood.
It's not the bullet with my name on it that concerns me,
It's the thousands of others marked 'occupant'.