After Zip backup, AW 3.0 won't print!

[ronlouie@u.washington.edu (Ron Louie)]

I've checked my Deskjet/Harmonie/Grappler+/AW manuals, the FAQ and I'm
still frustrated!  Through my RAMFast/SCSI on my ROM 01 IIGS, I daisy
chained an Iomega Zip to my LaCie Tsunami HD to back it up.  I had to
change the SCSI ID # from 5 to 6 on the Tsunami, since the Zip only allows
5 and 6, and I still needed to boot from the Tsunami, hence give it the
higher number.  Of course, one of my partitions disappeared, I had to
figure out the cryptic RAMFast utilities again, but I think I was
successful with the backup.  Now, I can no longer print from AppleWorks
3.0!!!  This used to work; in fact, the set up still works from AWGS 1.1.
I've checked the control panels; I recopied SEG.ER from Howard Katz's
compilation of SEG.ER's and interface codes; I've tried different versions
of custom printer. After hitting OA-P and answering the questions, the
thermometer fills quickly and sends me back to the Review/Add/Change
screen.  No action from the printer.  What gives?  It's as if it's dumping
the data into the ozone.  Does the SCSI ID# change, RAMFast or the backup
have anything to do with it?  Thanks in advance....Ron