[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Mountain Multifunction Card
- Subject: Re: Mountain Multifunction Card
- From: adrianw@cassius.ee.usyd.EDU.AU (Adrian Whichello)
- Date: 1996/07/28
- Distribution: inet
- Newsgroups: comp.sys.apple2
- Organization: Department of Electrical Engineering, Sydney University
- References: <4tbuji$27om@news.gate.net> <4tc68d$kp1@cello.gina.calstate.edu>
In article <4tc68d$kp1@cello.gina.calstate.edu>,
Steve Jensen <sjensen@cello.gina.calstate.edu> wrote:
>louiss@gate.net (Louis Schulman) writes:
>> Well, what does anyone know about the Mountain Multifunction card?
>> It evidently is at least a clock card and a serial card, but what else?
>> Unfortunately, I don't have the cables, and there are connectors and jumpers
>> all over the place. What do I connect where?
>>
>> Is there software for this card? Manuals? Anyone gots?
>
>Yea, I have a Mountain CPS Multifunction card with manual and software.
>It's a serial, parallel and clock card for an Apple ][. An AA battery
>holder powers the clock and keeps the config in the card's memory. It
>works in any slot except 0. It needs a special chip socket that goes
>under the 74LS138 at H12 on the motherboard and is connected by 2 wires
>to the pins at J6 on the card. I don't have the socket. :(
>--
> _________________________________
> | |
> | sjensen@qnis.net |
> | sjensen@cello.gina.calstate.edu |
> |_________________________________|
>
Weren't you Bob Jensen last time I looked :-)
I also have the old manual and an old disk (original is DOS 3.2, but I have a
copy in 3.3, that had to be "fiddled" to work - muffin or whatever the
conversion program was wouldn't touch it). I also have a copy of all the email
Bob and I shared about the card last year. You don't need the jumper wire and
IC plug/socket to do useful work with the card, only if you want to use the
"phantom slots" remapping feature.
Adrian Whichello Phone: +61 2 351 4824
Imaging Science and Engineering Laboratory Home: +61 47 588 319
Sydney University Electrical Engineering Fax: +61 2 351 3847
Australia Email: adrianw@ee.usyd.edu.au
"I wish to God these calculations had been executed by steam!" - C. Babbage