RamFAST & CD-ROM problem

[mportune@telerama.lm.com (Matt Portune)]

Every time I power up my system after it hasn't been used in while, I get 
past the load fill-bar, then it drops into 80-col text mode with the 
original startup text at the top and bottom of the screen, and a RamFAST 
"searching the SCSI bus" message on top of that in the upper left corner 
of the screen.  When I power down, then up again, it works.  This started 
happening after I hooked up an Apple CD-300ePlus to the SCSI bus with my 
hard drive.  I have a RamFAST Rev.D 3.01e 256k, and I already had those 
"problem chips" replaced by Sequential.  I also have the short timeout 
option set to YES.  Any idea what's going on here?  I hate having to 
start up twice.  :)

-- 
      /--- Matt Portune --------------------- pGSi 16/64 (loaded) -------\
      |  mportune@telerama.lm.com           Modular Euphoria MIDIStudio  | 
      |  ae094@dayton.wright.edu            Blue Monday BBS              |
      \------------- "The Computer is a drug, not a tool" ---------------/