Re: RRRGRHGRRHGRRR!!!!!!!!!

[nathan@cco.caltech.edu (Nathan Mates)]

In article <3ju8o7$39r@tusk.lm.com>,
Matt Portune <mportune@telerama.lm.com> wrote:
>ok, before I toss my GS... can somebody please decode this "easy-to-read" 
>RamFAST error message?  (It was on the 80 column screen, cutting out 
>every other letter... I'm not sure if the spacing is correct...)
>
>a F S / C I i   e r h n   h   C I b s
>o   e i e   t i   a   a e u   o
>5 s c n s s   l a e b   a i n )

   I think that's the standard message when it's scanning stuff,
roughly "The RamFAST/SCSI is not scanning the SCSI bus for
devices. (This may take up to 45 seconds)" That error happens when the
SCSI drives are not responding to the Ramfast (try turning them on
maybe 30 seconds before the GS), possibly a termination problem also.

   Then again, maybe not. Hold down '0' on turning on the GS to go to
the RamFAST menus and such. 

Nathan Mates
-- 
<*> Nathan Mates http://www.ugcs.caltech.edu/~nathan/      <*>
# "When you hear the voice of heaven, go out and start running. No
# matter how far away, set on a journey to be sure. ... No matter
# how far away, I'll be there to meet you." -- Silent Moebius #1