Re: RamFAST bullcrap

[mportune@telerama.lm.com (Matt Portune)]

> Set your Short Timeout option to YES in your RAMFast control panel (the
> one that you get when you launch RAMFAST.SYSTEM or hold down 0 when you
> boot your computer.  Also, if you don't start your hard drive up before
> you start your computer, or save your configuration after setting up the
> hard drive (OA-S), it may keep doing that.  Otherwise, call Sequential
> Systems at 1-800-999-1717.

I've gotten so many replies to this problem with my RamFAST, and I thank 
you all.  However, I already posted a reply a while ago, but I don't 
think it got posted, so I'll post it again.  I don't have any unused 
partitions, because the new drive was completely formatted and 
partitioned with the RamFAST, and the old drive was completely removed.  
I found out that if I turn on the system about 5 seconds after turning on 
the HD, it works properly.  The short timeout option STILL isn't long 
enough.  The delay message still appears.  I will have to live with this 
because my setup makes it extremely difficult to power up peripherals 
seperatly. (The whole thing is rack mounted in a studio and it's on the 
very top.  Oh well, at least I know what the problem is.  Thanks again to 
all!

-- 
 /-------------------------------------------------------\
 |  Matt Portune   - IIGSi -   mportune@telerama.lm.com  |     
 |                             ae094@dayton.wright.edu   |      
 \-------------------------------------------------------/