Re: RamFAST bullcrap

[mportune@telerama.lm.com (Matt Portune)]

Paul Schultz (schultp@aa.wl.com) wrote:
> Matt Portune (mportune@telerama.lm.com) wrote:
> : When you normally install a new harddrive, and turn on the machine, 
> : RamFAST says "Searching the SCSI bus for devices... could take 45 
> : seconds" or something like that.  Then it never does it again.  What does 
> : it mean when it says that EVERY time you turn on the machine?  This never 
> : happened until I put in my new hard drive.  What's going on?

> Perhaps you need to check your SCSI termination? Usually the RamFast
> won't display this message after it "learns" about your new device.
> What do you see when you enter the SCSI utilities built into the RamFast?

I know.  on my old drive, it "learned" once, but on this one, it never 
seems to "remember".  I see all the online partitions when I go into the 
utilities.  Everyone is saying it is because I have an unconnected device 
still listed (which would normally be right) but I don't.  The drive was 
completely re-formatted and partitioned using the RamFAST, so everything 
that is listed is actually there.  Any other ideas?

-- 
 /-------------------------------------------------------\
 |  Matt Portune  - PowerGS -  mportune@telerama.lm.com  |     
 |                             ae094@dayton.wright.edu   |      
 \-------------------------------------------------------/