Appleworks 2.0 and 4 meg RAM???

[twdorr01@starbase.spd.louisville.edu (Thomas Dorris)]

I have an Apple ][gs ROM 01 running System 6.0.1 with a GS Juice Plus,
equipped with 4 meg RAM.  Everything seems to be just peachy with my new
memory, except Appleworks 2.0!!!  It gets to the point where it starts
preloading Appleworks onto the memory expansion card and then it hangs
(Vulcan drive light just stays on)... Any ideas what might be going on 
here?  I've verified read and write to the ram banks by allocating a
4096K RAM disk and running COPY II PLUS to verify the whole thing...no
problems.  One thing I don't like is the fact that my new rams are 120 ns
while my older 2 meg is 100... Will that cause some problems later and would
faster rams do any good at all?

The last interesting point about this situation is that if I set the 
jumper switches on the card so that it's configured for 3 meg, Appleworks
comes up just fine.  It's that magical 4th bank that's making it throw
fits... Any help would be greatly appreciated.

ThomasD