SCSI Problem part2

[scraft@trident.usacs.rutgers.edu (Steve Craft)]

Terry's Tech:
 
Thanks for the SCSI ID setting info.
 
I set my drive ID to 4, and the startup delay to 13 seconds.  Booting from my
smartport 3.5" drive with my original Apple HighSpeed SCSI utils, I went to
low-level format and partition with four 1meg partitions.  Ater the drive
whirred and lcicked for far too long, a message finally came up "IO error".
 
So I pulled the Pegasus out again and set the SCSI ID back to six with the
startup delay to 13 seconds.  Using the Apple utils again I got the message
"Getting read errors, cannot format" so I put the whole thing back in the box
and will ship it back to Econ Technologies.  Something must have happened in
transit to me from Florida or something, I hope.  The drive just quit after I
turned the system off and then on again after 10 minutes or so.