Re: mini-FAQ: upgrading TransWarp GS/Zip GS

[90taobri@wave.scar.utoronto.ca (TAO BRIAN T)]

In article <mdmCA7xD9.Aqq@netcom.com>, Mark Miller writes...
> 
> When you install your new 4-pin crystal, be aware that it must be placed
> near the bottom end of the socket.  

    Bottom end?  This is what the underside of the crystal and the
socket look like:
	 _____	
	|-----|		 ____
	|o   o|		|.  .\
	|o   o|		|    |
	|o   o|		|    |
	|o   o|		|    |
	|o   o|		|    |
	|o   o|		|    |
	|o   o|		|.  .|   
	|-----|		\____/

	socket		crystal

    The crystal is the same length of the socket, but only pins 1, 7, 8
and 14 are present.  Three corners are rounded and one is "sharp".  I'm
told the sharp corner should go in the upper-left corner.  Can someone
confirm this?  If that's right, Frank should add this to the FAQ.
--
Brian Tao:: taob@io.org (Internex Online, 416-363-3783, 10 lines, v.32bis)
::::::::::: 90taobri@wave.scar.utoronto.ca (University of Toronto, 9T4)