Re: bypassing modem port

[kkenn@cola.pax.tpa.com.au (Kristian Kennaway)]

clueung@pro-acsd.cts.com (Chantha Lueung) writes:

> If I wanted to bypass the modem ports firmware which max. out at 19200 bps
> how would I do it from basic?  I want to get up to 57,600 bps?
> this is on a IIgs.
> 
> ProLine:  clueung@pro-acsd
> Internet: clueung@pro-acsd
> UUCP:     crash!pro-acsd!clueung

Ack!! BASIC? Assembler, maybe (I know it has been done - Z-link, for 
example). But I seriously doubt you could do it from BASIC without a few 
problems (for 1, BASIC is waaaay too slow to handle IO at anything near 
that speed).
 
Good luck,
Kristian


 _______________________________________________________________________
|       ______    ______       |                                        |
|      |____  |  |  ____|      |      | /  __    __ _|_    __   __      |
|    .......| |  | |.......    |      |<  /   | (_   |  |  __| |  \     |
|   :  .... | |  | | ....  :   |      | \ |   | __)  |  | (__| |  |     |
|  :  :    :| |  | |:    :  :  |                                        |
| :  :      | |`'| |      :  : | | /  __   __   __   __         __      |
| :  :      | |'`| |      :  : | |<  /__\ |  \ |  \  __| | | |  __| \  /|