Re: Help: Remove Jumper Block on SSC (repost)

[dmz@cco.caltech.edu (Daniel Zimmerman)]

chang@ee.ualberta.ca (Wui Chong Chang) writes:

>Sorry for the repost, I think I made a mistake on the last post.

>Here is the question. On the Super Serial Card, how do I remove the
>Jumper Block which is firmly attached to the circuit board ?
>Should I use soldering iron to remove it ??
>Please help.

Well, you shouldn't have to use a soldering iron - the jumper block should
pull right off (II assume you refer to the jumper block which has a white arrow
on it pointing either to the word "Printer" or "Modem" on the board, and 
wherever it is pointing now, you want it pointing the other way)... Just pull
it straight upward and it should come out of its socket, and you can then
turn it around. If this doesn't happen, then you have some kind of problem
with the board, and I'd bring it to an Apple dealer and have it looked at... :)

>Thanks.

>--
> _ __
>' )  )      /              /
> /--' o _. /_  __.  __  __/
>/  \_<_(__/ /_(_/|_/ (_(_/_

>chang@ee.ualberta.ca

-- 
--------------------------------------------------------------------------------
Daniel Zimmerman - TFF Enterprises                 Internet: dmz@cco.caltech.edu
MSC #1023, California Institute of Technology           AOL: Surak TFF
Pasadena, California  91126-0001  USA            CompuServe: 76407,2246