"vladitx" <vladitx@nucleusys.com> wrote in message ae7a9b4e-0524-46fe-981a-1cbff1634f29@h28g2000yqd.googlegroups.com">news:ae7a9b4e-0524-46fe-981a-1cbff1634f29@h28g2000yqd.googlegroups.com...
On Apr 17, 7:39 pm, A2Aviator <a2avia...@gmail.com> wrote:
Except that you're not indicating it locks up,you probably are just getting errors and it's moving across the screen really fast.Just showing read/write errors, all retries exhausted. If the I/O shadowing is off, then it won't access the real hardware and so it won't even start the motor. But then if the code first waits for data latch to change it should have aborted since it must be reading the same RAM location over and over. But I've never looked into the code so I just speculate.
As you may be aware, there were 2 versions of the ROM03 firmware. If you have the earlier prototype version, then this could be the cause of your difficulty, although being that I don't use Locksmith very much, I couldn't be sure. There may even be 3 versions of the ROM.
Garberstreet Electronics http://www.garberstreet.com