Re: opening the 2c brick psu

["phil" <pjwylie@gmail.com>]

>
> You don't mention whether the 12v power supply you used was regulated,
> or what the actual voltage was when the //c was switched on, but if it
> can supply 12v under load, it should work.
OK, I found the problem..
When I crimped the strain relief in the back of the power in DIN plug,
It shorted the plus with the housing ground, so plugging in the lead
in shorted my 12V psu. Oops. The fuse f1 (yellow, behind power switch
inside 2c unit) did pop also, so if anyone knows what to replace it
with, that would be good. I'm using a 2A one for now...

My 15V brick outputs no power at all, so if anyone can please give me
a hint on where the plastic casing is welded together... Thanks.