ADTPro 0.1.5 IIGS WinXP problem

[Mark McDougall <msmcdoug@no.spam.iinet>]

Hi all,

In my last post I asked about using the SSC in a IIGS for ADTPro...

However in the end I opted for the IIGS modem cable which I received on 
Friday, so no need to complicate matters with the SSC (and I'm lazy).

Also, I hooked up a pair of 5.25" Disk II drives with a Disk II interface in 
slot #4. In Control Panel I set slot#4 to "My Card" and Startup Slot to 
"Slot 4". In case it matters, display is 80 characters.

With this configuration I can boot 5.25" DOS3.3 and Lode Runner, for example.

I downloaded and installed ADTPro 0.1.5.

I can start a transfer of EsDOS II without any problems, but somewhere 
between 1/3 and 1/2 way thru the transfer, the IIGS screen stops scrolling. 
The ADTPro server continues sending until the transfer completes. Not 
surprisingly, no prompt on the IIGS screen either.

If I press <ENTER> on the IIGS after it stops, I get...
"00/2800:00 00 00 ..."

Any ideas? Is it because I have an extra Disk II interface in the memory map?

Ultimately I'm trying to get a 3.25" bootable DOS (ProDOS?) and also GSOS v5 
onto 3.25" floppies.

Regards,

--
|              Mark McDougall                | "Electrical Engineers do it
|  <http://members.iinet.net.au/~msmcdoug>   |   with less resistance!"