Re: Floppy to DOS Master

["Vince Briel" <vbriel@removethisspamcamcast.net>]

Yeah, I've done it with a version of copya I made. What I did was to take 
out the INIT command so it didn't try to format the the receiving disk 
(which is the CFFA volume).

I've also done it with ADT too but I can't remember the exact steps. I think 
I put ADT image into that volume and then ran ADT from that volume, then 
copied right over itself! ADT does not format a disk and that's what you 
need because DOS MASTER is loaded in the section of DOS where the format was 
done.

Hope this helps, if not I'll copy a disk and post all the steps.

Vince

replica 1 SE now available
http://www.brielcomputers.com

"Guillaume Tello" <houten.van@wanadoo.fr> wrote in message 
news:45e803ef$0$5092$ba4acef3@news.orange.fr...
> Hi,
>
> Here is my problem, I have files on a floppy disk and I want to copy them 
> to a DOSmaster volume on my CFFA. But....
>
> FUD refuses to copy the files (it says that it's not a DOS 3.3 disk).
> C2P refuses to copy files (it reports an error)
>
> But COPYA works very well from one floppy to another and the program works 
> well from a floppy, no error possible.
>
> So... Is there a kind of COPYA program that can make an exact image of my 
> floppy into a DOSMaster volume? (from S6,D2 to S7,D1,V15) ???
>
> Knowing that there's a chance that the floppy and the DOSMaster volume may 
> have differences in the number of sectors or tracks...
>
> Guillaume.
>