Super Serial Card Question?

["Nama" <lord_philip@mac.com>]

Ok, so I'm trying to get Apple II+, ADT, Super Serial Card (SSC) and my
IBM laptop running hyperterm (or mac 2400c with zterm) all working
happily together. I have read the many threads on the forums about
jumper seting etc, and none of it is any help thus far.

My first question is :

When trying to do a direct connect to the PC laptop running hyperterm,
using IN#2 (where 2 is the slot where my SSC resides), I get the
following:

C220 -      A=A0   X=00   Y=A0   P=B4   S=C9
  (Beep Sound)
C214 -      A=A0   X=00   Y=00   P=36    S=c3
  (Beep Sound)
C21C ...

etc...
(stops somewhere after 3 to 15 lines...seems quite random)

Now I've never done this before but I would expect that if all the
settings are consistent (Parity off, Baud rate the same etc) then what
ever I type into hyperterm should appear on the Apple II screen.

Doing a PR#2 does absolutely nothing. Screen goes blank...nothing else
happens.

Any advice would be greatly appreciated.

Thanks again
cheers

Phil