Re: Uncooperative RamFast

[Antoine Vignau <antoine.vignau@laposte.net>]

10.0  SYSTEM SETUP

If you bought your RamFAST/SCSI and hard drive as a package they
should be configured to work together from the start. If that is the
case your hard drive should boot right up after the hardware
installation is done. If this is the case you can skip the rest of
this discussion and start using your hard drive. Otherwise, continue
reading for information on how to get your system up and running.

If this is the first time you have used your computer with the
RamFAST/SCSI the utility program should auto-boot on its own. But, if
for some reason it does not, you can force it to come up by holding
down the "0" (zero) key when you turn on your computer. (Make sure
that you hold it down for a few seconds *AFTER* the RamFAST/SCSI
displays its "Searching the SCSI bus..." message appears or until the
utility program screen appears.)

Once you are in the utility program go ahead and click <<OK>>* if any
other message appears (Configuration Data Missing* is the most
likely).