Re: Setting the jumper on the Super Serial Card

[dalloff@gcfn.org (Dave Althoff Jr)]

olcott (olcott@qwest.net) wrote:
: I don't see any jumper to set. I can
: find the dip switches easily enough,
: but, I can't find a jumper.

: *** NOTE *** I must set this
: jumper to "terminal" rather than
: "modem" so that I can use this
: card with ADT.

See that 16-pin chip with the triangle on it, the word "MODEM" printed
above it and the word "TERMINAL" below?  That's the jumper block.  The
point of the triangle needs to point in the appropriate direction.

If you prefer, you can leave the jumper block alone and connect a
null-modem adapter to the 25-pin port on the back of the card and achieve
the same result.

--Dave Althoff, ][.
-- 
    /X\        _       _               _*** Closed for the season ***
   /XXX\      /X\     /X\_      _     /X\__      _     _        _____  
  /XXXXX\    /XXX\  _/XXXX\_   /X\   /XXXXX\    /X\   /X\      /XXXXX
_/XXXXXXX\__/XXXXX\/XXXXXXXX\_/XXX\_/XXXXXXX\__/XXX\_/XXX\_/\_/XXXXXX