Re: Micromodem Info??

[Doug Browning <wpg750@mb.imag.net>]

Here's the specs for the Micromodem II from the manual:

data format: serial, binary, asyncronous 7 or 8 data bits, 1 or 2 stop bits, odd, even,
or no parity.

lower case characters: can be optionally converted to upper case, or can be passed
through unmodified

firmware: 1024 byte read only memory (ROM)

power consumption: 1.5 W. Typical

card size: 7" x 3" including connector fingers

microcoupler size: 5 1/2" x 3 1/4" x 1 3/8"

modem compatibility: Bell System 103-compatible originate or answer mode, dial pulse
dialing and auto answer
  -50 dBm recieve sensitivity
  -10 dBm transmit level
110 or 300 baud data rates

FCC regristration: Fcc registration No. Bl986H-62226-PC-E
  ringer equivalence 0.4B
  connects with modular jacks RJ11W or RJ11C

supplied with: modem interface card, firmware in ROM, microcoupler, diskette, connector
cables, complete owner's manual.

Bryan aka R.I.P. wrote:

> On Wed, 09 Aug 2000 06:25:43 GMT, Dave Morrison <deth@idx.com.au> wrote:
>
> >Can anyone tell me the difference between the micromodem, micromodem II
> >and micromodem III. I assume its mainly baud speed??
>
> Well, if I'm not mistaken, I belive that the MicroModem was a cupler(sp!) modem (the
> kind you stuck the handset into, and the MicroModem II was a full-length internal
> card with wall jacks connecting to the card. I'm not sure on the III thought...
>
> Bryan
> gmezero @ gz.bomb.com



--
Doug Browning
dougbrow@mb.imag.net
www.mb.imag.net/~wpg750