Re: screen editor with S-C assembler: howto?

[pausch@saafNOSPAM.se (Paul Schlyter)]

In article <8hj66r$4rc$1@nnrp1.deja.com>,  <jaoswald@my-deja.com> wrote:
 
> I have downloaded the S-C assembler package, recently made available.
> 
> One of the disks (SCREENED.dsk) claims to have a full-screen editor.
> I have booted that disk in an emulator (Catakig on a PowerMac), and run
> SYSGEN as instructed to customize the editor program for the emulator
> setup.
> 
> However, I can't figure out how to actually run and use the editor!!
> 
> Can anyone give me a clue about how this thing actually works?
 
I can probably do that -- after having consulted the printed
documentation which accompanied that package.  And it's out in my
country house, but within a few weeks I should be able to access it.
 
Which points to the documentation problem: nowadays documentation
are usually distributed electronically, but back then documentation
was usually distrobited in printed form only.  So I should probably
scan in these documents and make them available.  In time I will....
 
-- 
----------------------------------------------------------------
Paul Schlyter,  Swedish Amateur Astronomer's Society (SAAF)
Grev Turegatan 40,  S-114 38 Stockholm,  SWEDEN
e-mail:  pausch at saaf dot se   or    paul.schlyter at ausys dot se
WWW:     http://hotel04.ausys.se/pausch    http://welcome.to/pausch