[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Super Serial card help!!
Mark Smith writes ...
>
> Can someone point me to an online schematic of the super serial card dip
> switches? I need to set mine from null to terminal so I can transfer some
> stuff but don't have the manual.
....
Since you do not have a manual, here is some SSC info posted by Tom Kelly which
may be useful in the future:
>>
SUPER SERIAL CARD (SSC) SETUP SETTINGS
Recomended slots:
slot 1 for terminal use (e.g. printer)
slot 2 for communication use (e.g. modem)
Jumper Block:
for communication use label is upside down (arrow points up)
for terminal use label is right side up (arrow points down)
Note that RS-232-C signals on the SSC use negative-true logic; that is, they
are true at 0v and false at +5 volts.
SW1 Dip Switch Settings:
Baud SW1-1 SW1-2 SW1-3 SW1-4 SW1-8
50 on on on off not used
75 on on off on "
110 on on off off "
135 on off on on "
150 on off on off "
300 on off off on "
600 on off off off "
1200 off on on on "
1800 off on on off "
2400 off on off on "
3600 off on off off "
4800 off off on on "
7200 off off on off "
9600 off off off on "
19200 off off off off "
Switch Settings For Communication mode:
SW1-5; SW1-6; SW1-7 are all set on
Data Parity Stop SW2-1 SW2-2 SW2-3 SW2-4
Bits Bits
7 none 1 on off off on
7 odd 1 on off on off
7 even 1 on off off off
7 none 2 off off off on
7 odd 2 off off on off
7 even 2 off off off off
8 none 1 on on off on
8 odd 1 on on on off
8 even 1 on on off off
8 none 2 off on off on
8 odd 2 off on on off
8 even 2 off on off off
Note: SW2-1 thru SW2-4 settings can be overridden by software.
SW2-5:
ON for linefeed out
OFF for no linefeed out
SW2-6:
ON for baud rates greater than 1199 baud
SW2-7:
OFF in communication mode
SW2-8:
Not used
Connector Pin Assignments
10-Pin Dsub-25
Header Connector Signal Name
______________________________________________________
1 1 Frame Ground
2 2 Transmit Data (TXD)
3 3 Receive Data (RXD)
4 4 Request To Send (RTS)
5 5 Clear To Send (CTS)
6 6 Data Set Ready (DSR)
7 19 Secondary Clear To Send (SCTS)
8 7 Signal Ground
9 20 Data Terminal Ready (DTR)
10 8 Data Carrier Detect (DCD)
Pins 1-7 and 2-7 are set together to determine the SSC pin to be read
for the Hardware Handshaking signal. Generally set to monitor Pin #20.
Common Configurations: [Don't Forget The JUMPER Block]
Hi Speed Modem ImageWriter I/II
1234567 1234567 1234567 1234567
ON XXXXXX XXXXXX X XX X XX
OFF X X XXX X XX XX
<<
Rubywand