Re: Prograppler printer interface . . .

[supertimer@aol.com (Supertimer)]

wbdesnoy@acs2.acs.ucalgary.ca (Byron Desnoyers Winmill) wrote:

>Hello,
>
>I would appreciate some information on how to setup the ProGrappler printer
>interface card, such as jumper settings (I'm using a Star NX-10 printer at
>the moment, but regularly pickup used printers) and some basic information on
>programming for it.

I think it was an updated Grappler+ card.  The ProGrappler had a mouse
driven interface instead of the primitive one on the Grappler+.  It also
had built in DeskJet support, I think.

Assuming Grappler+ controls, the ProGrappler may be accessed by
typing PR#N (N=slot of ProGrappler card) and then issuing a Control-I.

I think.  I have not used an Orange Micro card of any type for a long time.