[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Sider HD

Hi again.  I have a Sider model 9710-H.  I have a Xebec card (rev.H).  I have
them connected with a db37-db37 ribbon cable.  I have what appears to be the
right software (6 disks).  There is a jumper on the last set of pins on a
block on the back.

When I run the install software, and get to the point of installing the DOS
3.3 partition, I get an error message "sense bytes not found"  and something
about a RAM error.  If I move the jumper to any other location or remove it,
the drive isn't seen.

I don't have the manual.  Can anybody help?  Is this fixable or is the drive
simply broken?

Thanks,  Louis

(Note to Steve Mentzer:  I can be just as condescending on other days of the 
week.  But really, if you have nothing to add or ask, why post?)