Re: Wolf3D trouble...it's me...

[dalloff@freenet.columbus.oh.us (Dave Althoff)]

Supertimer (supertimer@aol.com) wrote:
: dalloff@freenet.columbus.oh.us (Dave Althoff) wrote:

: >I have this nagging suspicion that if I can get Wolf working, I can
: >probably get HyperCard working, too...

: You have a CV Tech 4MB memory card with an Apple 1MB on the
: CV Tech pocket?  Try turning off DMA on the Apple High Speed
: card.  With any luck, both Wolf and HyperCard will run.

Congratulations and thanks to Supertimer for not only correctly
identifying my RAM board as a CV Tech (I hadn't looked at it in so long I
didn't remember what kind it was...) and telling me that I had DMA turned
on on my HS-SCSI, but for also solving my Wolf3D problem.

Now I just need to get my TWGS working.  I think it needs a CPU cable, and
while I am at it, I might as well upgrade the CPU and oscillator...I
should probably also get a memory card that properly supports DMA 'cause
now my disk access is slow...

I haven't tried HyperCard GS since turning off DMA, but now Wolf3D works
*without* shift-booting.  Very cool!  Now if you'll excuse me, I've got
some Nazis to kill...  8-)

--Dave Althoff, jr.
-- 
    /^\        _       _              ***  Closed for the season  ***
   /XXX\      /X\     /X\_      _     /X\__      _     _        _____  
  /XXXXX\    /XXX\  _/XXXX\_   /X\   /XXXXX\    /X\   /X\      /XXXXX
_/XXXXXXX\__/XXXXX\/XXXXXXXX\_/XXX\_/XXXXXXX\__/XXX\_/XXX\_/\_/XXXXXX