AE Parallel Pro card

[adrianw@cassius.ee.usyd.edu.au (Adrian Whichello)]

Hi All,

I bought an Applied Engineering Parallel Pro card in a job lot. No docs. Could
somebody please tell me:

1) what is the pinout on the DB-25 fmale connector, so I can connect it to my
printer (Epson LX-800 which has a centronics parallel plug),

2) what the 10 pin connector on the board does (which is separate to and above
the 26 pin connector that goes to the DB-25),

3) what the STB/not STB jumper is for?

Thanks for any info. The switch settings I've already found on ground.

--
Dr Adrian Whichello                                  Phone: +61 2 9351 5339
Imaging Science and Engineering Laboratory             Fax: +61 2 9351 3847
Sydney University Electrical Engineering      Email: adrianw@ee.usyd.edu.au
Australia                           WWW: http://www.ee.usyd.edu.au/~adrianw

"I wish to God these calculations had been executed by steam!" - C. Babbage