Re: Ramfast rev.D and Tower case

[rubywand@swbell.net]

S�nke_Behrens wrote:

> .... 
> The Rev. C had a 50-pin connector, yes (not always soldered, but
> there). The Rev. D has only a 25-pin connector. I can think of no
> "good" way to solve this other than soldering a short adapter. ....
>

     The Rev. D RamFAST board has a short cable going from the card to the 
25-pin socket. You could mount the socket in the back of the tower case and 
plug in a 25-->50-pin cable to connect your SCSI HD or CD-ROM. Alltech sells 
25-->50-pin SCSI cables.

     If the cable on the RamFAST card is not long enough to reach the back of 
the tower case, you could plug in the 25-->50-pin cable from Alltech and run 
it through a slot in the back of the case. A couple wire ties could secure 
the cable to the case so that there would be no danger of yanking out the 
RamFAST when connecting the 50-pin end to your SCSI device.
 

Rubywand