Re: disk ][ speed adjustment

[pbauer@athena.mit.edu (Paul H Bauer)]

 >Dakin Williams (ddwilliams@bosco.meis.uab.edu) wrote:
 >: It has been some time since I've had to adjust the speed on my Disk][
 >: drive.  Long enough, in fact, that I've forgotten how to do it!  I
 >: pulled the cover off the drive, but none of the screws jumped out
 >at me: as being the correct one to turn.   So I turned a few on the analog
 >: board and behind, but none changed the disk speed as it ran.  Page146
 >: in the DOS Manual didn't illuminate much for me.
 >:
 >:       Can anyone with keen powers of description tell me exactly which
screw: (?) it is that changes the speed of the drive?  Location, color,
 >nearby: landmarks, etc.?  I am surprised to have forgotten this!
 >:
 >:
 >: D. Williams
 >
 >When you pull the cover off, on the very back halfway up the sidethere's
 >a little blue block mounted horizontally with a screw.. it's on the right
 >side of the drive.. I assume your running a disk speed analysis program...
 >Think it might be kinda hard to calibrate it otherwise.....
 
 
        Actually its easier than you think. If you have a way to make the