Re: IWII startup problems

[be404@yfn.ysu.edu (Adalbert Goertz)]

You wrote:

        Take the cover back off.  At the bottom right edge (right?  at the
same corner as where the power switch is when the cover is on the
printer), look and see if the magnet might have fallen out.  This will be
MORE noticeable by the fact that the case does NOT have a dark chunk glued
to it, if the magnet has fallen off ... <B-)

Adalbert Goertz responds >>>>>>>>>>>>
Yes, I finally figured out where the magnet was missing, played with another
magnet and made the blinking disappear, glued it on the cover and it seems
ok now.
THANKS for this good advise.
-- 
*************** Adalbert Goertz ****** ph 717-762-7378 ********
retired in Waynesboro PA (65 miles from Baltimore/Washington DC
Mennonite genealogy;insect studies;selling/trading insect books
Would anyone trade my PA home for house in CO,NM,AZ or ? ? ? ?