Coming soon: IBM-to-IIe and IBM-to-IIgs power cables

[buggie@enzu.unm.edu (stephen e buggie)]

These are not yet ready but will be by the end of April; that's why I'm 
posting it here rather than at the A2.marketplace.

I am gearing up to produce a dozen power adaptor cables for the IIe and 
IIgs, to run them from IBM-AT power supplies.

PLUG-IN CABLES:   (attaches via plug to power-points P8 and P9 on IBM 
      power supply:   5 ft cable to attach to motherboard power point
      in IIgs or IIe:     $14.00 each, plus $2.00 postage. (Specify
      either IIe or IIgs version).

CABLE SOLDERED TO IBM-AT POWER SUPPLY  (power supply included):
      5 ft cable.   Power supply rests on floor under computer table;
      cable enters back of computer and plugs into motherboard.)
      SPECIFY whether for IIe or IIgs, so correct plug is used.
      150 watt power supply:     $27 plus $5 shipping within U.S.
      200 watt power supply:     $30.00 plus $5.00 shipping  within U.S.
         (Note: Your weak Apple II standard power supply is merely
         60 watts ---- no wonder your Apple freezes and crashes so often!)


CABLES:  heavy duty AWG-18 wires, with 600v insulation.  All connections 
wrapped with shrink-tubing; no messy electrical tape.   All cables and 
power supplies will be fully tested prior to shipping; an instruction 
sheet will be printed so that voltages can be checked prior to connecting 
it to your motherboard.  High current lines (+5v and + 12v) will be 
AWG-copper annealed insulated wires; low current lines will be AWG-18
insulated wires of Jameco mystery metal.   These wires are the heaviest 
gauge that the connectors will accommodate.

The cables will be finished by April 20th.   To allow time for testing, 
they can be shipped by April 30th.

Steve Buggie			buggie@unm.edu
UNMG
200 College Rd.
Gallup, NM  87301