Re: RAMFAST.SYSTEM Question

[scottw@onyx.southwind.net (Scott Weierich)]

RUBYWAND (rubywand@aol.com) wrote:

:     Since my hard disk is independent of the SCSI interface, the RAMfast
: rev.D v3.x is connected to just a CD-ROM drive. Everything-- DiscQuest,
: CD-ROM music player, Golden Orchard-- works great, except that there seems
: to be no way to SAVE the RAMfast "Option" settings to hard disk. 

:     When I run RAMFAST.SYSTEM from the RAMfast ROMdisk (or anywhere else)
: and click "Install", it says to select a target volume. However, it lists
: only whatever volumes may be accessed via CD-ROM and the ROMdisk under
: GS/OS Volumes. No hard disk volumes are shown.

:     The problem is not getting the RAMfast driver into the SYSTEM/DRIVERS
: folder; it's easy enough to just copy it from ROMdisk. The problem seems
: to be that Install is supposed to set the destination for saving the
: RAMfast config info. 

:     When "Options" are set and "SAVED" they will remain in effect through
: a re-boot from the desktop. They are forgotten when power is turned OFF. 

:     So, what is wrong? How can the settings be saved to hard disk?
:  

--
Can I ask the million$ question??!! Why is you hard drive not connected 
to the RAMfast? In reply to your question, I believe that the card can 
only look at the SCSI bus and since your hard drive isn't there, your out 
of luck! If your drive isn't a SCSI drive, buy one whenever possible and 
connect it to this card. Drives are more affordable than ever and you 
simply won't believe the performance you'll receive!!

Scott