Re: Wow!

[sjensen@eis.calstate.edu (Steve Jensen)]

Spock-
Here's some signal to go with all the noise-
Grabbing an Imagewriter manual I find that dip switches 1-1, 1-2, 1-3 and
1-4 control baud rate.  For a printer set all except 1-4 open for 9600
baud.  For a printer, set 1-5 open & 1-6 & 1-7 closed.
Switch 2-1 should be closed for 8 data & 1 stop bit.  Set 2-3 open for
no delay.  Set 2-3 open & 2-4 closed. Set 2-5 closed for lf after cr.
Set 2-6 open for interrupts off and 2-7 open for normal cts.
On some dip switches open is the same as off and closed is the same as on.
Set the jumper block pointing up for a modem and down for a printer.

--
sjensen@eis.calstate.edu      8-()
                             - _ !    Still smokin'.