Q: ADT-transfers on Franklin ACE 2200 + Super Serial Card II

["DeaconBlue" <locksmith64@doramail.com>]

Thank you for your feedback and follow-up leads.

>I'm not sure how that would be possible.  ADTgs (http://
>www.apple2.org.za/gswv/USA2WUG/Utilities/adt/AdtGS/v91/readme.txt) was
>targeted at using the built-in firmware and serial port; that cabling
>would not be the same as would fit with the SSC card.

Yes, you are right.  I use a custom-cable setup consisting of 3 sections 
where section#3 is changed depending on which A2-based system to be used.

1)  PC Serial DB9/ DB25
2)  null-modem Adapter DB25/DB25  (+ gender changer(s))
3) Apple serial cable:   IIGS   (modem cable:  Mini-DIN8/DB25)  or for the
    SSC:   DB25/DB25-cable.

> I did not recall correctly.  The slot nearest the back of the computer
> is slot 2.  The slot nearest the front of the computer is slot 4 or 7,
> selectable at jumper JP7/JP8.

>But maybe you could try telling ADT to
>use slot 7?  As a matter of fact... if you haven't "saved" a
>configuration of ADT 1.33 yet, it should scan the slots for an SSC
> card itself.

With ADT v.133 the default slot was identified as:  S2, slot#2 provided 
there
was a scan performed initially.  I will try to switch to #7 and see if it 
makes
a difference independently of the JP7/JP8 setting.

Best regards



I