Re: ADT under Apple II emulation on Apple III?

["N.N. Thayer" <nnthayer@hotmail.com>]

I haven't gotten around to messing with any drivers yet, but I ran
into this doc...

http://www.apple2.org.za/mirrors/ground.icaen.uiowa.edu/MiscInfo/Misc/appleiii.sos

...which stated that the serial port was assigned slot 7 in emulation
mode.  Previously, I'd only tried the most common slots used for
serial cards.  I was hoping that I'd just been a total idiot, but no,
that didn't work.  :(

Also, I need to correct my description of the II emulation control
panel.  There is no selection for the SSC - unsurprising, since it
came out after the III - just "serial."  The full panel, with my
selected options in asterisks, is as follows:

LANGUAGE: *APPLESOFT* INTEGER BASIC
CARD: *SERIAL* COMMUNICATIONS
BAUD RATE: 110 300 600 1200 2400 4800 9600 *19200*
LINE FEED: *ENABLED* DISABLED
LINE WIDTH: 40 72 80 132 *INF*
CARRIAGE RETURN DELAY: *ON* OFF