Re: Cisco Router Config for A2 Ethernet

["brad" <mrbrad@ll.net>]

i think you are the same person who had up a metal/fv via this port

could you repost the telnet address...i've not been able to get on ..nor get
the error msg that it is being used...(ie in config)

brad
former sysop lost-gonzo.com

"Smohn Jith" <khorster@optonline.net> wrote in message
news:bqXhd.13944$6z2.7599213@news4.srv.hcvlny.cv.net...
> Here is my config with IP's changed.  You will have to set up your own
> configs.  This config is mainly set up for using the router as an IP port
to
> Serial port gateway for a BBS.  But you should be able to use it as telnet
> client.  You might also be able to do SLIP and PPP connections with it
also.
> This is on a 1700 series router.  Other series may work also.
>
>
> Router#show config
> Using 1761 out o
> !
> ! Last configuration change at 16:14:23 EST Mon Oct 18 2004
> ! NVRAM config last updated at 16:14:40 EST Mon Oct 18 2004
> !
> version 12.1
> service timestamps debug datetime msec
> service timestamps log datetime msec localtime
> no service password-encryption
> !
> hostname Router
> !
> logging buffered 4096 debugging
> logging console informational
>
> !
> !
> !
> !
> !
> memory-size iomem 25
> clock timezone EST -5
> clock summer-time EST recurring
> ip subnet-zero
> no ip source-route
> no ip domain-lookup
>
> !
> !
> !
> !
> interface Serial0
>  no ip address
>  shutdown
>  no cdp enable
> !
> !This is the router's interface to the net/LAN
> interface FastEthernet0
>  ip address 192.168.100.100 255.255.255.0
>  no ip route-cache
>  speed auto
>  no cdp enable
> !
> !This is the serial/aux ports interface and may vary from model to model
> interface Async5
>  ip address 192.168.101.1 255.255.255.0
>  no ip route-cache
>  async mode interactive
>  peer default ip address 192.168.101.1
> !
> ip default-gateway 192.168.100.1
> ip classless
> ip default-network 192.168.1.0
> ip route 0.0.0.0 0.0.0.0 192.168.100.1
> no ip http server
> !
>
> no cdp run
> !This is the BBS setup stuff
> banner incoming ^C
>
> Welcome to The BBS Gateway.
>
> Please type "1" <cr> to connect!
>
> ^C
> banner login ^CWelcome to The BBS^C
> !
> line con 0
>  transport preferred none
>  transport input none
> !Serial port/aux settings, timeouts, baud rate, etc.
> line aux 0
>  session-timeout 10
>  no activation-character
>  vacant-message ^C
> The server may be busy
> ^C
>  refuse-message ^C
>
> The BBS is currently in use.
>
> Try again later
>
> ^C
>  transport input all
>  autohangup
>  speed 57600
>  flowcontrol hardware
> line vty 0 4
>  password guest
>  login
> !
> sntp server 192.168.100.1
> no scheduler allocate
> end
>
>