[no subject]

Eric

"Zouplaz" <pouet@pouet.com> wrote in message
news:Xns940BC5F6C8EE5Zoupla@213.228.0.32...
> Bill Garber - willy4SPAM6pa@comXcast.net :
>
> > Is it possible you are using the wrong port on the GS?
> > The printer port (#1) will only transmit. Try the other
> > port and use slot 2. This is only a guess. I would think
> > that if you used the same cable before that it should work
> > again.
>
> No that was the port #2...
> And the port is configured as a "modem port" in the control panel.
>
> I really don't understand but it's true that maybe the wiring is not
> sufficient and maybe it just worked once due to computer mystery !
>