SCSI harddisk on enhanced IIe

["Allen Bong" <sfbong@tm.net.my>]

I bought a SCSI card with "ROM C' from ebay Australia and I followed the
instructions from  "The do-it-yourself SCSI hard drive manual" by Paladin to
make the DB-25(M) to 50 pin IDC SCSI cable.  Once the cables was completed,
I plugged it onto the  SCSI card (not HS) which sits on Slot 5.  The othere
end was connected to a 160 MB SCSI drive from an old Mac with built-in
terminator.

I run the SCSI test program, and it says no HD detected.  The HD is getting
power from an external 250W PS from a used PeeCee.  So I think it doesnt
overload the IIe's PS.

What did I do wrong?  Any clue from the group is much appreciated.

I also have a ROM1 IIgs and two ROM3 IIgs with one Focus card installed.
The instruction also mentioned "Advanced Disk Utilities" for IIgs.  Where
can I get this program?


Allen
Malaysia.