[no subject]

Termpower supplies +5V to the bus to supply active terminator modules.
Therefore, before combining SCSI and SASI devices make sure that this
line is not connected to ground by a SASI device. 


Your Apple III does not support the "PR#x" command. Therefore the
firmware on your card is not used, everything depends on the .DRIVER
file compiled into your SOS system software. Write a SCSI HD driver and
you can use a SCSI HD. Write a DVD R/W driver and you can connect a DVD
R/W drive.


Could you send me a copy of the driver you use with your HD, or post it
to one of the ftp servers? A regular *.dsk image file of the utility
disk would be fine.

TIA
Patrick